Modular Operation Theatre
Description
The wall and ceiling panel of Modular Operation Theatre can be made out of following material as per customer requirement. A) 1.6mm thick EGP steel panels backed by 12mm thick Gypsum. B) Stainless steel SS202 or SS304 panels. C) High-pressure Laminate panels as per EN standard. D) PUF sandwiched panel. The Operation room wall will have two independent surfaces with a minimum opening in between. The external walls of the Modular OT room will be constructed with solid bricks with cement plastering. The inner surfaces walls will be constructed with 1.60mm thick EGP steel panels backed by 12-mm gypsum board (India gypsum make) these panels will have flame resistance to BS1142
🗹 Theatre will be fixed to the bricks wall with essential supports. There will be minimum possible cavity/gap in between the solid and steel walls.
🗹 The total distance between the inside and outside surfaces of the operating room will be variable to suit the architect’s layout, but will be sufficient for the flush mounting of equipments
🗹 The individual wall panels will be spot welded together at equal intervals to render equal support to the panels. Spot welding will be properly grinded to make the surface leveled
Modular OT wall panels design and construction will allow for the installation and support of all equipment and the provision of opening required for the installation, without affecting rigidity and strength. Access boxes will be fitted to the rear of all wall mounted equipment to enable maintenance to be carried out from outside the hospital operating room. All the sharp edges and corners will be in radius to avoid bacterial contamination. The internal surfaces of the hospital operation room walls will be sprayed with water based liquid plastic, wall glaze or equivalent, approved by the architect to a minimum dry film thickness of 300 microns.
